How Tight To Nail Vinyl Siding

Secure interlocking panel design provides a tight fit with no insulation gaps.

How tight to nail vinyl siding.

Following is a discussion of how to do both. Center nails in slots. Also learn the right way to hang siding with insulation in mind. Allow approximately 1 32 0 8mm clearance the thickness of a dime between the fastener head and the vinyl.

The problem should be easy to diagnose. Integrated 1 thick eps rigid foam insulation nominal helps reduce utility costs and reinforces the siding. This will permit expansion and contraction as well as prevent dimpling which causes waves in siding. Between nail head and vinyl.

Do not drive the head of the fastener tightly against the siding nail hem. Vinyl siding can either be nailed by hand with a hammer or by a power nailer. Simply go outside grab the lower edges of a siding course and try to slide it back and forth photo 1. Drive nails straight and level.

Allow approximately 1 16 in. To install vinyl siding to the soffit and fascia area on your home nail lengths of j channel along the inner edge of the fascia leaving the nail heads out about 1 32 to 1 16 of an inch. Do not drive nails tight. An expert guide on the best way to nail vinyl siding either by hand or using a power nailer.

Prodigy one piece insulated siding system. Do not nail to the extreme right or left of nail slot in siding panel. For this reason manufacturers design it to hang loosely on the nails rather than to be tightly nailed like wood siding. For the best results leave at least 1 16 inch between the nail head and the siding to give it some room to grow.

Tight nailing screwing or stapling will cause the vinyl siding to buckle with changes in temperature fig. Next measure and cut the siding to fit the measurements of your soffit and push each panel into the j channel. Vinyl siding tends to expand and contract considerably with temperature changes.